How do I switch between magnetic heading and true heading ?
Most likely I'm overlooking it somewhere.
Da FAC?
How do I switch between magnetic heading and true heading ?
Most likely I'm overlooking it somewhere.
Providing CAS when you're all out of HUA!
Downloaded and installed version 1.7.2 but when you run each version shown in Windows Explorer:
C:/Program Files (x86)/Stra Software/Tacview/Tacview says it's 1.7.2 under "ABOUT"
However...
C:/Program Files (x86)/Stra Software/Tacview/Tacview64 say it's (still) 1.7.1 under "ABOUT"
But, the Tacview64 version has the R64 Circle guide when you load a replay while the Tacview version does not.
Is this just a possible internal naming "error" within Tacview?
Both the 32 bit and 64 bit exe's correctly show 1.7.2 in the new version. Is it possible you have multiple versions installed? Check C:/Program Files (x86)/Tacview/...
Also, check your Control Panel to determine.
Definitely only one Stra Software folder under Program Files (x86)
Definitely only one Tacview choice in my Control Panel
Definitely TWO .exe files in the Tacview folder under Stra Software.
One Tacview and one Tacview64
The icon in my Control Panel does launch 1.7.2 according to the "About" tab in the app.
Don't look for "Stra Software". Do you have C:/Program Files (x86)/Tacview/?
If not, remove it entirely, delete the directories, re-install.
Ok, both .exe files in c:/program files (x86)/tacview...
...report as version 1.7.2
Guess I was pinning the wrong .exe file to my taskbar.
Thanks Dojo!